Pre-wiring your system:
Wiring taken:
The plots for each of the eight plots taken at the facility are connected by the cable 8 son.
Extending your installation .
Who can install additional outlets?
- The technical services of France Telecom.
- A company of your choice.
- Yourself, from an existing phone jack.
If your installation has at least one outlet, it is possible to change in order to add additional outlets.
If your phone is connected to a rose, you will need for the installation of catch, using the services of France Telecom technical or business qualified phone.
Precautions:
It is recommended prior to any intervention to isolate your installation by disconnecting the two son of the first row of the connector (pins 1 and 3) avoiding they touch. You just put them back in the late work.
Warning:
As an electrical installation, it is dangerous to change your telephone during a storm.
Recognize your installation:
It may be that your installation was carried out according to old standards. The different types of installation you can change are given in the table below.
| R EPRESENTATION diagram of the existing facility. | Block diagram of the system after adding an additional outlet. | Equipment to be used (see "Materials"). | Observations (see "Wiring"). |
|---|---|---|---|
 First dose to 6 blocks. |  6 studs 8 studs | - 1 to 8 pin socket - a test module - 4 pair cable | Installing new standard if you plan to completely redo your installation, it shall conform to the wiring to the above case. |
First dose to 8 blocks. | 8 blocks 8 blocks | - 1 8-pin socket - 4 pair cable | |
 First taken in 8-pin & ring. |  6 studs 8 studs 8 studs  | - 2 pin plug to 8 - a test module - 4 pair cable - flexible cord 2 pair - one phone jack - a 2.2 uF capacitor |
Taken within a six blocks. Within an 8-pin socket.
Wiring phone jacks:
TYPE 1:
from a 6-pin socket.
If the plug is fitted with a wire or a strap (wire) between pins 1 and 5, or a capacitor, it must be removed.
TYPE 2:
from an existing 8-pin socket.
TYPE 3:
taken from a 6-pin associated with an extra bell. If the plug is fitted with a wire or a strap (wire) between pins 1 and 5, or a capacitor, it must be removed. It should be taken to conform with the existing wiring diagram-cons.
Use with a second line.
No comments:
Post a Comment